Warranty - Craftsman 358.360150 Instruction Manual

TROUBLESHOOTING TABLE - Continued
TROUBLE
Oil inadequate
for bar and
chain
lubdcation.
Chain moves at
idle speed.
Chain does not
move when en-
gine is acceler-
ated.
Chain darers
or cuts roughly.
Chain stops
within the cut.
Chain cuts at
an angle.
CAUSE
1. Oil tank empty.
2. Oil pump or oil fiRer
clogged.
3. Guide bar oil hole
blocked.
1. Idle speed requires
adjustment.
2. Clutch requires repair.
1. Chain tension too
tight.
2. Carburetor requires
adjustment.
3, Guide bar rails
pinched.
4. Clutch slipping,
5. Chain brake engaged.
1. Chain tension incorrect.
REMEDY
1. Fill oil tank.
2. Contact Sears Service.
3. Remove bar and clean.
1. See =Carburetor Adjustment" in the
Service end Adjustments Section.
2. Contact Sears Service.
1. See =Check Chain Tension" in the
Maintenence Section.
2. See =Carburetor Adjustment" in the
Service end Adjustments Section.
3. Repair or replace.
4. Contact Sears Service.
5. Disengage chain brake.
1. See "Check Chain Tension"in the
2. Cutters damaged. 2.
3. Chain worn. 3.
4. Cutters dull, impropedy 4.
sharpened, or depth
gauges too high.
5. Sprocket wom. 5.
6. Chain installed 6.
backwards.
Maintenance Section.
Contact Sears Service.
Resharpen or replace chain.
See "Chain Sharpening" in the
Service end Adjustments Section.
Contact Sears Service.
Install chain in dght direction.
1. Chain Cuttertops not
filed fiat.
2. Guide bar burred or
bent; rails uneven.
3. Clutch slipping.
1. Cutters damaged on
one side.
2. Chain dull on one side.
3. Guide bar bent or wom.
1. See =Chain Sharpening" in the
Service and Adjustments Section.
2. Repair or replace guide bar.
3. Contact Seers Service.
1. See "Chain Sharpening" in the
Service and Adjustments Section.
2. See =Chain Sharpening" in the
Service end Adjustments Section.
3. Replace guide bar.
If situations occur which are not covered in this manual, use care and good
judgement. If you need assistance, contact Sears Service or the CUSTOMER
ASSISTANCE HELPUNE at 1-800-235-5878.
YOUR WARRANTY RIGHTS AND
OBUGATIONS: The U. S. Environ-
mental Protection Agency and Seam,
Roebuck and Co., U:S.A., are pleased
to explain the emissions control sys-
tem warranty on your lawn and garden
equipment engine. All new utility and
lawn and garden equipment engines
must be designed, built, and equipped
to meet the stringent anti-smog stan-
dards. Sears must warrant the emis-
sion control system on your lawn and
garden equipment engine for the peri-
ods of time listed below provided there
has been no abuse, neglect, or im-
proper maintenance of your lawn and
garden equipment ehgine. Your emis-
sion control system includas parts
such as the carburetor and the ignition
system. Where a warrantable condition
exits, Sears will repair your lawn and
garden equipment engine at no cost to
you. Expenses covered under warran-
ty include diagnosis, parts and labor.
MANUFACTURER'S WARRANTY
COVERAGE: If any emissions related
part on your engine (as listed under
Emissions Control Warranty Pads Ust)
21