Advertisement
Read these instructions and this manual in
its entirety before you attempt to assemble
or operate your new lawn mower. Your
new lawn mower has bden assembled
at
the factory with the exception of those
parts left unassembled for shipping
purposes. All parts such as nuts, washers,
bolts, etc., necessary to complete the
assembly have been placed in the parts
bag. To ensure safe and proper operation
of your lawn mower, all parts and hardware
you assemble
must be tightened
securely.
Use the correct tools as necessary
to
ensure proper tightness.
TO REMOVE
LAWN MOWER FROM
CARTON
• Remove loose parts included with
mower.
, Cut down two end corners of carton and
lay end panel down flat.
• Remove
all packing materials
except
padding between upper and lower
handle and padding holding operator
presence control bar to upper handle.
, Roll lawn mower out of carton and check
carton thoroughly for additional
loose
parts.
HOWTO
SET UPYOUR
LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
• Raise handles until lower handle section
locks into place in mowing position,
• Remove protective padding, raise upper
handle section into place on lower
handle and tighten both handle knobs.
• Remove handle padding holding
operator presence control bar to upper
handle.
• Your lawn mower handle can be
adjusted for your mowing comfort.
Refer to "Adjust Handte" in the Service
and Adjustments section of this manual.
Operator Presence
Control Bar
Upper Handle
Up
Lift Up
Mowing Position
Lower Handle
Advertisement
