Sears Craftsman 917.256451 Owner's Manual page 135

TO REPLACE HEADLIGHT _ =_
o Raise hood_
o Pult bWb holder out of the hole in the backside of the
grill.
o Replace bulb in holder and push buib hoider securety
back into the hole in the backside of ._hegriii.
o Close hood,
INTERLOCKS AND AELAYS
Loose or damaged widr_ may cause your tractor to run
pooriy, stop Rmnin{:_ or prevent it from sta_ing.
,9
D ADJ
... :+:,.,# _at wiring diag;am in Repair
Check wirinft See _::"_"_ :._ : ' °
Replace with 30 amp automotive-4ype D,, .,._qJrjfuse. The
fuse holder is located btmmd the dash..
TO Bai_!tOVE _4OOD A_',il© GRILL, ASS_i_aBLY
(S,.(_® # i$ 2M
o Raise hood.
Unsnap headiight wire connector.
o Stand in front oftracton Grasp hood at sides, ti_ttovvard
entwine and lift off of tractor,
To replace, reverse above procedure.
-4N
TO ADJUST THROTTLE CONTROL OABL£
(See Fig. 27}
The thro_tte contro_ has been preset at the factors; and
adjustment should not be necessaPy. Check adjustment as
described beiow before loosening cabte. If adjustment is
necessary, proceed as fot_ows:
With engine r_ot ru,qnin_, move throttte control iever
from siow (_@**)to choke ('_,) oosit:,on. Slowly inove
fewer from ono_,t (I _,,) ,.o fao. (_ #...;.::;4wn.
Check that holes "A" in governor centre! lever ar,_dho!e
in governor plate line-up. If holes "A" are r_otaiigned_
loosen clamp screw and move throttle eabie untiJ .qoies
are aiigned. Tighten clamp screw securely°
GOVERNOR GOV:_£_;_iOR
OONTBOL £_VE}S_ ©O_'_TROL PZ.AT£
/
¢ i
o
O
F_G. 26
23