Replacing Battery; To Replace Headlight Bulb; Interlocks And Relays; To Remove Hood And Grill Assembly - Craftsman 917.273396 Owner's Manual

2. Connect one end of the BLACK cable
to the NEGATWE (-) terminal (C) of
fully charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
02614
Weak or Dead Fully Charged
Battery Battery
REPLACmNG BATTERY
_I, WARNmNG: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position.
2. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5. Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and keps nut. Tighten securely.
Positive
(Red)
Cable
Terminal
Cover
Negative (Black)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3, Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill,
4. Close hood.
iNTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
o Check wiring. See electrical wiring
diagram in the Repair Parts section,
TO REPLACE FUSE
Replace with 20 amp automotivemtype
plugqn fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRmLL AS-
SEMBLY
1. Raise hood,
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re=
connect the headlight wire connector.
Hood
Headlight Wire
Connector
Seat
Label
O2495 "
25