Craftsman 3One 917.372910 Owner's Manual page 7

ASSEMBLY
TO ASSEMBLE AND ATTACH GRASS
CATCHER (See Figs. 3A thru 4C )
To assemble tubular frame to grass bag, work sewn
hem of bag out through the front opening of bag to
expose the hem..
o Thread tubular frame into hem and gather material at
top of frame as shown.
° Push frame inside bag through the opening until only
the ends of frame are exposed out of the front,.
NOTE: Do not close the flip lid at this time.
o Assemble lower frame to tubular frame as shown. Be
sure frames are fully seated together as shown in inseL
• Slip vinyl bindings over frame°
NOTE: If vinyl bindings are too stiff, hold them in warm
water for a few minutes° If bag gets wet, let it dry before
using.
° Closethe flip lido Flip lid must be closed while operating
Fawn mower°
• Lift the rear door on the mower housing and place the
grass catcher frame onto the formed tabs on the rear
door hinge brackeL
. The grass catcher is secured to the fawn mower
housing when the rear door is lowered onto the grass
catcher frame.
F ,_k CAUTION: Do not run your lawn mower
i ,_,_ without clipping deflector or approved
| _ grass catcher in place. Never attempt
i _ to operate the lawn mower with the rear
! ............. ... door removed or propped,,open: ....
I
SEWN
HEM
(Pull out
through front
of opening)
FLIP LID
TUBULAR
FRAME
(Push inside
bag)
FIG. 3C
LOWER
TUBULAR
FRAME
(Frames must
be fully seated)
FIG. 4A
CATCHER FRAME
\
FIG. 3A
FIG. 4B
TUBULAR
FRAME
(Thread into
sewn hem)
SEWN
HEM
FIG, 3B
HINGE
BRACKET
FORMED
TABS
7
FIG, 4C