Craftsman 3One 917.252531 Owner's Manual page 22

SE ViCE D ADJU ENTS
........ ,, ........... , ,,, ,,, u==, iHi .........................
I/I II!l ,,,,,,,,,,,,,,,,,,,, ,, ,,, ' ' .............. II IIII Illlll
Q
O
m
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fullyand set.parking brake.
Place motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
, Turn ignition key "OFF" and remove key.
- Make sure the blades and all moving parts have completely stopped.
, Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TRACTOR
TO REMOVE
MOWER (See Fig. 21)
Mower willbe easier to remove from the right side of tractor'.
• Place attachment clutch in "DISENGAGED" position,.
• Move attachment lift lever forward to lower mowerto its
lowest position.
= Roll belt off engine pulley.
= Disconnect clutch rod from clutch lever by removing
retainer spring_
° Disconnect anti=sway bar' from chassis bracket by
removing retainer spring°
° Disconnect suspension arms from rear deck brackets
by removing retainer springs.
° Disconnect front links from deck by removing retainer
springs.
° Raise lift lever' to raise suspension arms. Slide mower
out from under tractor_
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR, THE
R.H. AND L.H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR.,
TO INSTALL MOWER (See Fig. 21)
. Raise attachment lift lever to its highest position,.
° Slide mower under'tractor with discharge guard to right
side of tractor',
• Lower lift lever to its lowest position.
o Install mower in reverse order of removal instructions.
CLUTCH
RETAINER
SPRING
ANTI-SWAY BAR
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 21
UTCH LEVER
22