EFI Fiery X12 User Manual page 6

For Port, select the COM port (or the USB port on newer Mac OS computers) to which
the EFI ED-100 is connected.
10. Measure each color patch using the EFI ED-100.
11. Continue measuring every color patch on the Measurement Page, being sure not to skip
a single patch.
It is critical that you take the measurements in the order outlined in the
N :
OTE
Measurements dialog box and on the Measurement Page.
12. When all patches have been measured successfully, click Accept.
13. In the Measure dialog box, click OK.
14. In the Calibrator window, click Apply to implement the new calibration data.
15. In the Information dialog box, click OK.
This completes the calibration process using the EFI ED-100.
Tray Alignment
Tray Alignment is a feature that allows you to adjust small shifts that may occur during the
printing process. Greater shifts should be addressed by an authorized technician. You can
perform Tray Alignment from the Command WorkStation. The procedure is described in
the following section.
After you perform Tray Alignment, you must reRIP any previously RIPped jobs that
N :
OTE
you have saved. This allows the new alignment settings to be applied to the saved jobs.
T
O PERFORM AND VERIFY TRAY ALIGNMENT FROM THE
1. Verify that the DocuColor 12 is within the correct registration specifications.
2. Print a test job from the application and verify the registration of the document.
3. Select Align Paper Trays from the Server menu.
4. Select the tray (1-4, 6) you want to align from the Tray menu.
C W S
OMMAND ORK TATION
Page 6
Part number: 45022476