Advertisement
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de-
scribed below before loosening cable. If
adjustment
is necessary, proceed as
follows:
1. With engine not running, move choke
control (located on dash panel) to full
choke position.
2. Remove air cleaner cover, filter and
cartridge plate to expose carburetor
choke (see "AIR FILTER" in the
Maintenance
section of this manual).
3. Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw
securely.
4
Reassemble
air cleaner.
Choke Closed
Cas,o0
_lcae rTwp d
_
Choke
.._
Lever
TO ADJUST CARBURETOR
The carburetor has been preset at the
factory and adiustment should not be
necessary. However, minor adjustment
may be required to compensate for
differences in fuel, temperature, altitude or
load. If the carburetor does need adjust-
ment, proceed as follows:
In general, turning the mixture screw in
(clockwise) decreases the supply of fuel
to the engine giving a leaner fuel/air
mixture. Turning the mixture screw out
(counterclockwise) increases the supply
of fuel to the engine giving a richer fuel/air
mixture.
IMPORTANT=
Damage to the needles
and the seats in carburetor may result if
screw is turned in too tight.
PRELIMINARY
SETTING -
1. Be sure you have a clean air fUter, and
the throttle control cable and choke
are adjusted property (see above).
2. With engine off turn idle mixture screw
in (clockwise)
closing it finger tight and
then turn out (counterclockwise)
1-1/4
to 1-1/2 turns.
FINAL SETTING-
1. Start engine and allow to warm for five
minutes,
Make final adjustments
with
engine running and shift/motion
control lever in neutral (N) position.
2. With throttle control lever in slow
position, hold throttle lever against idle
speed screw and adjust idle speed
screw to obtain 1200 to 1400 RPM.
3. While still holding throttle lever against
idle speed screw, turn idle mixture
screw in (clockwise)
until engine
begins to die and then turn oat
(counterclockwise)
until engine runs
rough. Turn screw to a point midway
between those two positions.
4. Continue to hold throttle lever against
idle speed screw and adjust idle
speed screw to obtain 900 to 1200
RPM. Release throttle lever.
ACCELERATION
TEST -
5. Move throttle control lever from slow to
fast position.
If engine hesitates or
dies, turn idle mixture screw out
(counterclockwise)
1/8 turn. Repeat
test and continue to adjust, if neces-
sary, until engine accelerates
smoothly.
High speed stop is factory adjusted.
Do
not adjust - damage may result.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed
setting can be dangerous. If you think the
engine-governed high speed needs
adjusting, contacta Sears or other qualified
serVF-.ecenter, which has proper equip-
ment and experience to make any
necessary adjustments.
ldleSpeed
crew
Idle Mixture
Screw
Throttle Lever
Idle Speed
Screw
__
Throttle
_
!d_
_"
_":;:_==C_::_._3_
J M_xture
Lever _crew
28
Advertisement
