Special Cycles - Bosch WFK 2401 Use And Care Manual

simply depress the "ON/OFF" button. The machine
will stop. The machine will restart approximately from
the point where it was tumed off when the "ON/OFF"
button is again depressed.
To end a cycle that has begun:
Set the cycle selector to any of the "X" settings,
see Figure 16. The indicator light above the
"START" button will begin to flash.
Note: The "X" setting that appears a number of times
on the cycle selector knob is the reset position.
This setting is used to reset the programming.
_, Depress the =START" button.
Set the cycle selector to a SPIN (8) or SOFT
SPIN (9) or DRAIN (6) cycle.
_. Depress the "Start" button. The washer will spin
dry and drain or just drain and "CL" will appear in
the alphanumeric display when done. The washer
door can theh be opened and the wash removed.
If you wish to change the cycle after it has begun:
_, Turn the cycle selector to "X" The indicator light
above the "START" button will begin to flash.
Depress the "START" button.
_. Turn the Cycle selector to the cycle desired.
Depress the "START" button.
_. The new cycle will begin.
Notes: 1. Do not add more detergent as the water in
the machine has not been pumped ouL
2. If the washer is interrupted during "Wash',
"Spin', or Drain" selection the clothes will
not be rinsed and there may be soap
residue.
Mte_d [ lOOQ
Figure 16.
You can add clothes to the wash load as long as the
"Wash" indicator light is illuminated.
• Depress the "On/Off" button.
• Wait until the "Door Locked" indicator light goes
off.
• Open the door and add clothes.
• Close the door by pushing it shut firmly until it
snaps into place with an audible click.
•
Depress the "On/Off" button. The machine wig
restart approximately at the point where it was
turned off.
SPECIAL CYCLES
Rinse/Spin (11) & Soft Rinse/Spin (10) (and
Starching)
A separate rinsing cycle followed by spinning. Used
for rinsing individual items that have been washed by
hand, for starching, or for flushing detergent residue
from the washer after too much detergent has been
used. The Soft Rinse/Spin (10) is specially designed
for permanent press and delicate items.
To use these settings for rinsing (includes
spinning):
1. Place the wash to be rinsed in the washer.
2. Pour fabric softener into the fabric softener
compartment (the middle compartment in the
dispenser drawer, marked _), if desired.
3. Depress the "On/Off" button.
4. Set the cycle selector to RINSE/SPIN (11) or
SOFT RINSE/SPIN (10).
5. Set the spin speed selector to a specific speed, or
INTERVAL SPIN, or NO FINAL SPIN, if desired.
6. Depress the "START" button. The indicator light
for "Rinse/Spin', in the cycle progress indicator
will become illuminated.
15