Clearing Commands; Clearing Learned Commands; Master Clear; Input - X10 IconRemote IR18A Owner's Manual

Clearing Commands

To Clear All Learned Commands Under a
Mode
Clearing learned commands is helpful if you replace
your CD player with another brand or model, for
example. If your remote had learned a feature (such as
RANDOM PLAY) from your old CD player's original
remote, that feature would no longer work for your new
CD player.
If you want to remove or clear one or more learned
commands, do the following.
1. Press and hold SETUP until the indicator remains
on, then release SETUP.
2. Press and release SELECT to select the mode you
want to clear (TV, VCR, etc.).
3. Press and release LEARN twice. The indicator blinks
off.
4. Press and release SETUP. The indicator turns off. All
learned commands under that mode are now cleared.

Master Clear

Master Clear - To Clear All Learned
Commands Under All Modes
1. Press and hold SETUP until the indicator remains
on, then release SETUP.
2. Press and release LEARN twice. The indicator blinks
off.
3. Press and release SETUP. The indicator turns off. All
learned commands in the remote are now cleared.
18

INPUT

When in TV mode, INPUT performs the INPUT source-
switch function.
When in a mode that has been programmed for VCR,
INPUT performs the TV/VCR antenna-switch function.
When in a mode that has been programmed for Cable,
INPUT performs the A.B-switch function.
When in a mode that has been programmed for DVD,
INPUT performs the DVD-setup function.
When in a mode that has been programmed for SAT,
INPUT performs theTV/SAT switch function.

Troubleshooting

Remote does not operate your product
1. Select the mode for the product you want to control.
2. Program the remote with a new code.
3. Install new batteries in the remote. (You might have
to reprogram your remote after installing new
batteries.)
4. If these steps do not work, the remote might not be
compatible with your product.
Remote does not operate some features of
your product
1. Program remote with a new code.
2. If this does not work, your remote might not be able
to operate all features of your product or the button
names might be different than your product's.
Indicator blinks after you program a product
code
1. This means the remote did not accept the code.
2. Try to program the code again or try a different
code.
19