Electrical Grounding Instructions; Pressure Testing - Jenn-Air EXPRESSIONS CVGX2423B Installation Instructions Manual

Manifold Pipe
Appliance Pressure
Regulator, supplied
(Observe directionality
of Gas Flow)
Flare Union
Adaptor
Flexible
Appliance
Connector
(5 ft. max.)
Figure 3: Alternative Gas Connections

Pressure Testing

This appliance must be isolated from the gas supply piping
system by closing its individual manual shutoff valve during
any pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 PSIG (2.5 k pa).
This appliance, as well as its individual shutoff valve, must
be disconnected from the gas supply piping system during
any pressure testing of the system at test pressures in
excess of 1/2 PSIG (3.5 k Pa).
When checking for proper function of the appliance
pressure regulator, make certain pressure of natural gas
supply is between 6 and 14 inches of water column or, if
converted for LP gas, between 11 and 14 inches.
To Electrical
Outlet
To Blower Motor
1/2² NPT Pipe
Nipple
Gas Shut-Off
Valve
1/2² NPT Pipe
Flare Union
Adaptor
Gas Shut-Off
Valve
1/2² NPT Pipe
Connecting Appliance To Electricity

ELECTRICAL GROUNDING INSTRUCTIONS

This appliance is equipped with a three-pronged grounding
plug for your protection against shock hazard and should be
plugged directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from this plug.
The electrical supply required is 110/120 Volts A.C., 60 Hz,
with 15 amp. circuit protection. This appliance is equipped
with a grounded type power cord. A grounded outlet must
be provided. It is recommended, for convenience, this outlet
be located in the shaded area in figure 4.
User may experience occasional circuit tripping if Ground
Fault Circuit Interrupter (GFCI) outlet or breaker is in use.
Figure 4: Recommended Location of Electrical Outlet
This appliance, when installed, must be electrically
grounded in accordance with local codes or, in the absence
of local codes, with the latest edition of the National
Electrical Code ANSI/NFPA No. 70 USA or current CSA
STANDARD C22.1 Canadian Electrical Code, part 1.
4
WARNING