Clearing Jammed Staples - Woodstock SHOP FOX W1778 Owner's Manual

Model W1778 18 Gauge Deep Stapler Kit
DO NOT place your hands near the
staple point of entry. A staple can
deflect and tear through the surface
of the workpiece, puncturing your
hand or fingers.
Deflection is caused when grain
irregularities, knots or foreign objects
inside the wood cause the staple
to change its path, resulting in the
staple puncturing the surface of the
workpiece, as shown in Figure 5.
Besides damaging your workpiece,
deflection can cause injury if your
free hand is securing the workpiece in
the location that the staple deflects.
Figure 5. Example of staple deflection.
5. Pull the trigger.
— If the staple drove into the wood
far enough, continue with your
intended operations.
— If the staple either went too far
or not far enough, then adjust the
air pressure. More air pressure
will increase staple depth, less
air pressure will decrease staple
depth.
Single Fire Operation
The stapler is designed to fire one staple
at a time.
To operate your stapler in single fire
mode, do these steps:
1. Depress the safety nose mechanism
against the workpiece.
2. Pull the trigger, then release the
trigger after the staple is driven.
Clearing Jammed
Staples
A jammed staple must be cleared before
using the stapler again.
To clear a jammed staple from the dis-
charge area, do these steps:
1. DISCONNECT STAPLER FROM THE AIR
SUPPLY!
2. Unlock the catch lever and slide the
magazine pusher all the way back.
3. Remove the staple stick from the
magazine.
4. Flip the quick release latch, as shown
in Figure 6, and open the cover.
Quick
Release
Latch
Figure 6. Nose opened to clear a jam.
5. The jammed staple should now be
visible; remove it from the discharge
area with needle nose pliers.
-9-
Cover
Discharge
Area