Maintenance And Troubleshooting; Caring For Your Tv; Extended Ab,,,Ence; Tv Picture Interference - Zenith SY1324S Operating Manual & Warranty

MAINTENANCE AND TROUBLESHOOTING
CARING FOR YOUR TV
"Your TV will look better, have a longer life and perform better
if you care for it properly.
First check to see that the TV is off. For added
safety, unplug the TV from the power outlet.
NOTE: If you mplug your TV, you will have
to reset the clock to the current time.
CABINET CARE
Non-Wood Cabinet or Cabinet Components Moisten a soft
cloth with a mild soap solution or Ivory dishwashing deter-
gent. Wipe the surface with a damp cloth. Then rinse the cloth
in clean water and wipe the surface again. Allow the TV to air-
dry before turning it on.
Wood Cabinets or Cabinet Components Use any good fur-
niture cleaner and polish. Regular care will help preserve the
finish.
PICTURE GL._,SS CLEANING
The picture tube face attracts dust particles and
should be cleaned regularly. To clean the face,
spray a small amount of glass cleaner on a
cleaning cloth and wipe the picture tube glass
face until clean. Repeat if necessary.
To delay new dust accumulation, wet a soft
cloth in lukewarm water in which a little fabric
softener or Ivory dishwashing detergent has
been mixed. Wring the cloth ahnost dry. Wipe
the glass face. Make sure no drops of moisture
are squeezed onto the glass. Do not wipe the
glass dry. Allaw the glass to air-dry before you
turn the TV on again.
EXTENDED ABSENCE
Before an extended absence (such as a vacation) you may
want to unplug the power cord from the electrical wall outlet.
This will protect the TV from possible damage from lightning
or power line surges. If you have an outdoor antenna, you may
also want to disconnect the antenna lead-in wires on the back
of the TV.
NOTE: If you unplug your TV, you will have to reset the
clock to the current time.
TV PICTURE INTERFERENCE
Your TV picture may be affected by interference caused by
one or a number of factors. These include:
Speckled re;Streaked Picture Can be caused by nearby auto-
mobile ignition, electrical appliances, etc. This is most notice-
able in weak signal areas.
Snow in Picture Caused by insufficient signal. Usually
caused by the TV being located too far from the TV station or
by an improper antenna installation.
Ghosts or Reflections Caused by signals being reflected
from surrounding buildings, water tanks, or other high struc-
lures.
Radio Signal Police, amateur or CB radio transmitters may
cause
interference.
These interference problems can often be corrected through
the use of a better antenna, silgnal amplifiers, or various filter
devices. See ),our TV dealer for additional infc, rmation, and
available TV accessories.
Y.SAREI)IR 7- 1