Table of Contents
Advertisement
Connecting
to a Digital
TV Receiver
By connecting a Digital TV Reciever, high definition pictures can be displayed on your TV in
their digital form.
DTV Decoder
DIGITAL OUT
AUDIO OUT
TV Rear Panel
HDMI to DVl Cable
After the connections
have been made,
tighten the screw to secure the cables.
1 ) Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to
the DIGITAL-IN on the back of your television.
2) Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO DIGI-
TAL-IN on the back of your television.
3) Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFTAUDIO
DIGI-
TAL-IN on the back of your television.
• The digital-in terminal is not compatible with the picture signal of a personal computer.
• Use a HDMI to DVl cable (commercially
available) in order to digitally connect the television
with a DTV decoder.
Notes:
• If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance
may be slightly shifted.
Access the "DIGITAL-IN"
in the initial setup menu to adjust it. (Refer
to page 47.)
• When you do the above connection,
set DIGITAL-IN AUDIO in the Initial Setup menu to
ANALOG.
See "DIGITAL-IN AUDIO",
page 47.
Advertisement
Table of Contents
