Altigen TRITON T1 User Manual

TRITON T1 BOARD
Q I
U I C K N S T A L L AT I O N
MVIP BUS
Termination Switch
The Triton T1 Board uses the following signaling and framing features:
Signaling: loop start, ground start, E&M immediate start, E&M wink start*
Line Encoding: AMI, B8ZS*
*recommended
M S R
INIMUM YSTEM
• IBM/PC AT compatible system with adequate number of full-size ISA and PCI slots
• 233 Mhz Pentium processor (or better)
• 2 - 4 GB Hard Disk Drive Space (depending on voicemail requirements)
• Windows NT Server 4.0 with Service Pack 4 (or higher) installed
• 128 MB RAM
• AltiGen's Quantum Telephony Board (one or more, Rev. D or higher)
• AltiGen's Triton T1 Board (one or more)
• AltiWare OE R3.0 (or higher)
• 300W/10A CPU Power (minimum required to power AltiGen boards only)
• CSU (Channel Service Unit)
# of AltiGen Boards
1 Triton T1, 1-3 Quantum
1 Triton T1, 1-6 Quantum
1-4 Triton T1, 1-10 Quantum
# of AltiGen Boards
1 Triton T1, 1-3 Quantum
1 Triton T1, 1-6 Quantum
1-4 Triton T1, 1-10 Quantum
** The above system requirements are for AltiGen components only, and do not take into account requirements for other
system components such as motherboard, disk drives, etc.

LED Indicators

GREEN LED
OFF
ON
OFF
ON
OFF
Alternating
*** Faulty signals include the following: yellow alarm, bipolar violation or frame error
G
U I D E
MVIP Connector
TRITON T1 BOARD
:
EQUIREMENTS
# of Slots** CPU HDD
2 PCI, 3 ISA 233 Mhz 2GB
2 PCI, 6 ISA 300 Mhz 2GB
5 PCI, 10 ISA 350 Mhz 4GB
Power Supply**
+12V: 4.2 Amps +5V: 6Amps
+12V: 8.4 Amps +5V: 10.8Amps
+12V: 14 Amps +5V: 21Amps
RED LED
OFF
OFF
ON
Flashing Faulty signal with frame synchronization***
Flashing Faulty signal without frame synchronization
Alternating
System
Configuration Switch
Typical Power Supply
300W/30A@5V/12A@12V
400W/40A@5V/16A@12V
400W/40A@5V/16A@12V
Status
No power
Normal operation
No signal
Frame slips in normal operation