Front Panel Header - Gigabyte GA-H61M-S2PH User Manual

5) SATA2 0/1/2/3 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header
according to the pin assignments below. Note the positive and negative pins before connecting the cables.
Power/Sleep LED
F_PANEL(NH)
BIOS Switcher (X58A-OC)
1
M_SATA
1
PWM Switch (X58A-OC)
3 2 1
DIP
DIP
1 2 3
SATA2
1 7
0
1 7
1
2
1 7
3
1 7
Power Switch Speaker
2 20
1 19
Hard Drive Reset Power LED
Activity LED Switch
Chassis
Intrusion Header
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch,
power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this
header, make sure the wire assignments and the pin assignments are matched correctly.
PORT
DEBUG
PORT
DEBUG
PORT
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
• PLED/PWR (Power/Sleep LED):
Connects to the power status indicator
System Status LED
on the chassis front panel. The LED is on
S0 On
when the system is operating. The LED is
S3/S4/S5 Off
off when the system is in S3/S4 sleep state
or powered off (S5).
F_PANEL
• PW (Power Switch):
(H61M-D2)
Connects to the power switch on the chassis front panel. You may
configure the way to turn off your system using the power switch
(refer to Chapter 2, "BIOS Setup," "Power Management," for more
information).
• Speaker (Speaker):
Connects to the speaker on the chassis front panel. The system reports
system startup status by issuing a beep code. One single short beep
will be heard if no problem is detected at system startup.
• HD (Hard Drive Activity LED):
Connects to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the
reset switch to restart the computer if the computer freezes and fails
ACPI_CPT
to perform a normal restart.
(GA-IVB)
• CI (Chassis Intrusion Header):
Connects to the chassis intrusion switch/sensor on the chassis that can
detect if the chassis cover has been removed. This function requires
a chassis with a chassis intrusion switch/sensor.
SMB_CPT
(GA-IVB)
- 13 -
CLR_CMOS
CI
DIS_ME
GP15_CPT
(GA-IVB)
PWM Switch (SW1)(X79-UD7)
5 4 3 2 1
DIP
BIOS_PH
(GA-IVB)