Table of Contents
Advertisement
The label location artwork is not available yet. Please ignore this part when you review this HMM.
Note: Applying labels to the base cover The new base cover FRU is shipped with a kit containing labels of several
kinds.
When you replace the base cover, apply the following labels:
1
FCC label
4
Serial number label
Following labels need to be peeled off from the old base cover, and need to be put on the new base cover.
2
GEO label
3
Rating label
5
Ethernet label
6
Windows Certificate of Authentication label (COA)
7
Wireless WAN MAC label
For some models, you need to apply two FCC labels. Check the old base cover; if it has two FCC labels, apply
both to the new base cover.
For the location of each label, refer to the following figure:
1150 LCD unit
For access, perform the following steps in order:
•
"1000 Disabling the battery pack in UEFI BIOS" on page 48
• Remove the "1010 Hard disk drive or solid state drive assembly" on page 48.
• Remove the "1020 Keyboard" on page 50.
• Remove the "1030 Top case assembly" on page 52.
• Remove the "1080 Battery pack" on page 56.
.
Chapter 8
Removing and replacing a FRU
67
Advertisement
Table of Contents
