Pc Card Assembly - HP Compaq 8510p - Compaq Business Notebook Maintenance And Service Manual

k. Modem module (see
l. System board (see
Remove the RJ-11 connector cable:
1. Remove the RJ-11 connector (1) from the clip built into the base enclosure.
2. Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base
enclosure.
3. Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.

PC Card assembly

Description
PC Card assembly
Before removing the PC Card assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
Modem module on page
System board and system board frame on page
Battery on page 45).
Hard drive on page 49)
Optical drive on page
Keyboard on page 57)
84)
53)
Component replacement procedures
85)
Spare part number
455893-001
89