Grizzly G0588 Instruction Manual page 34

Power Cord
SECTION 2: CIRCUIT REQUIREMENTS
Components and Hardware Needed:
To connect the saw to the power source:
1.
Figure 47.
2.
Note:
phase converter, connect the manufactured
power leg to the S terminal. The S terminal
can handle power fluctuation because it is
wired directly to the motor. The other wires
connect to the transformer and must be con-
sistent to prevent damage.
3. Shut off the main power at the power
source circuit breaker
Qty
Figure 47
To test run the saw:
1.
2.
3.
Figure 47
When using a
Test Run
Before starting the saw, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety issues associated with this machine.
Failure to follow this warning could result in
serious personal injury or even death!
Troubleshooting