Grizzly T10499 Instructions Manual page 8

Note: You can make sure that the blade
ends are even with each other by stacking
them together with the teeth facing in oppo-
site directions (see Figure 11), then grinding
them. Regardless of the grinding angle, the
blade ends will match evenly for welding.
figure 11. Blade ends stacked with teeth facing
opposite directions.
3.
use 120-grit emery cloth or an equivalent
to lightly sand the part of the blade that will
contact the welder clamps. this helps ensure
a good electrical contact with the blade for
welding.
Note: To prevent dulling the teeth, keep the
emery cloth away from them when sanding
the blade surface.
Welding
1. turn the main on/oFF switch OFF, then
disConneCt WeLder FroM poWer!
2. thoroughly clean the welding clamps to
remove debris, oily substances, or flash from
previous welding operations. if necessary,
lightly sand them with 120-grit emery cloth.
-8-
3.
rotate the clamp
(see figure 12) to zero. this spreads the
clamps apart to allow proper positioning of
the blade ends.
Welding Clamps
Clamp Levers
figure 12. Clamping controls.
4.
pull the spark deflector up and loosen the
welding clamps by pulling the clamp levers
down.
5. position the back of one blade end evenly
against the back of the right welding clamp
so that the end is midway between the two
clamps, as shown in figure 13.
Blade
end
figure 13. Blade end properly position in
welding clamp and locked in place.
6.
rotate the right clamp lever up to secure the
blade end in place.
t10499/t10500 Blade Welder
pressure switch
Clamp
pressure
switch