Installing The Sensor Unit - Epson P260 User Manual

Installing the sensor unit

The sensor components are shown below.
Connector
Light detector
1. Set the sensor unit's light emitter in the bottom
of the drive unit, and then secure it with a
screw.
2. Set the sensor unit's light detector in the base
unit's bottom left side, and then secure it with
a screw.
4
3. Plug the connector of the sensor unit cable into
Light emitter
4. Fasten the cable using the cable clamps
the socket located at the top rear of the control
box on the drive unit.
provided. Use as many of the clamps as
necessary to secure the cable.You may need to
do this from the back of the printer.