Epson P-0082 Product Support Bulletin page 2

ESC X m n1 n2 (Select Pitch and Point Size)
C X m n1 a is the command for selecting pitch and point size where m, nl and
will always be 0 (zero). The variables In" and 91' ate explained below.
value far W, the character pitch will be proportional spacing. To determine the
character pit& for all other values of %I", divide 360 by "m". For example, if rn=W
then 360 divided by 60 equals 6 and the character pitch is 6 characters per inch. If
example, if nl=20, the point size is 10. tf nl=48, the point size is 24. NOTE:
When selectina a Doirft size laraer than 24 (the value for nl is treater than 4&
select twof3ortional wacina tm=ll for the character me&.
In the Basic programming language, the command would look like this.
character size. At this time, n2 is m zero (0).
PSB No: P-0082
Page: 2 of 14