Basic Operation; Turning On And Off The Tv; Choosing Tv Channel - ProScan 26LB30QD Instruction Manual

Basic operation
TURN ON LCD TV
1. Connecting to the AC input cable to switch on LCD TV. At this time the TV will enter standby mode and indicator show
red.
2. User POWER button or @ button on the remote control can turn on LCD TV from standby mode.
TURN OFF LCD TV
1. Press POWER button or @ button on the remote control to enter standby mode. The indicator is red.
2. Wait 5 second after switch off LCD TV then you can turn on LCD TV again.
1.
2.
3,
Using the CH A / CH • on the front panel or on the remote control.
• Press CH A to increase channeI number.
• Press CH • to decrease channel number.
Using 0-9 digital buttons and - button
You can select the channel number by pressing 0 to 9
Example:
IN ANALOG SIGNAL:
To select channel (e.g. Channel 22): Press 2 -> 2 ->ENTER,It wiiI jump to 22-0 directly
IN DIGITAL SIGNAL:
To select digit channel (e.g. Channel 22-1 ): Press 2 -> 2 -> - > 1 ->ENTER,the program wilI appear immediately
NOTE: Sub channel number of analog channel is always zero. But when you in the digital signal, if you enter
physical channel number and not end with "ENTER", channel selection will be made if there is no operation within
a few seconds.
14