Sony DSLR-A390 Instruction Manual page 32

ff dust or debris enters the camera and lands on the image sensor (the part
that acts as the fihn), it may appear on the photo image, depending on the
shooting environment. [f there is dust on the image sensor, use a
cormnercially available blower and clean the image sensor following the
steps below'. You call easily clean the image sensor using only the blower
and the anti-dust function.
Notes
• Cleaning can be performed only when lhe banery level is _ (Ihree remaining
battery icons) or more. Low battery power during cleaning can cause damage to the
shutter. The cleaning should be completed quickly. The use of an AC-PWlOAM AC
Adaptor (sold separately) is recommended.
• Do not use a spray blower because it may scatter water droplets inside the camera
body.
1
Confirm thatthebatteryis fullycharged (page18).
2 PresstheMENU button, t hen
select'_ 3 with_1/1_ onthe
control b utton.
...... ,_;_;iii!i!!!_!i_!ii!ii!ii!iiiiiiiiiiiiiiiiiiiiiiiiiiii!i ¸¸¸¸¸
_;; _ _ __ _ _ _ :i_ii!iiiii!ii ¸_ iiii!ill _ii_!!i_ii_ _,,,_> ::
MENU button
3 Select[Cleaning mode] withA_,
thenpress thecenterofthe
control b utton.
The message "After cleaning, turn
camera off. Continue'.'" appears.
4
Select[OK]with• onthecontrol b utton, a ndpressthecenter
ofthecontrol b utton.
Alter the image sensor vibrates for a short time, the mirror in front is lifted.
32