Sony BRAVIA HDMI VPL-AW15 Operating Instructions Manual page 52

Symptom CauseandRemedy
The picture is too dark. + Adjust the coutrast or brightness of the Picture _ menu
properly. (_ page 41 )
The picture is not cleat: + Adjust the focus using the R>cusring. ((_" page 24)
+ Condensation has accumulated on the lens. Leave the projector
lk)rabout 2 hours with the power on.
The picture flickers. + Activate "APA", then adjust the curreut input signal.
+ Adjust "Phase" for "Adjust Signal" in the Screen _ menu
properly. ((_ page 45)
On-screen display
Symptom CauseandRemedy
On-screen display does not + Set "Stares" in the Setup _ menu to "On." ((_ page 46)
appear. + Check it' the I/(_) (On/standby) indicator should light in green.
The model name does not + The display mode of the projector may be set at the time of
disappear l_'omthe screen, purchase. Consult with your local dealer or qualified Sony
personnel.
Remote control
Symptom CauseandRemedy
The remote control does @ Batteries could be weak. Replace them with ne'a batteries.
not work. ((_ page 11)
+ Insert the batteries with the correct polarities. ((_" page 11)
@If there is a lluorescent lamp near the remote control detector, the
proiector may work improperly or inadvertently.
Others
Symptom
The l_mis uoisy.
Cause and Remedy
+ Check the setting of "Cooling Setting" in the Setup _ menu.
((_" page 46)
+ Make sure that the room temperature is not too high.
The number of fan rotation increases to maintain the product
reliability of the projector's componeuts in a room, where the
temperature is higher than uormal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
52