Supplied Accessories; Symbols Used In This Manual; Attaching The Stand; Tilt Stand - Sylvania LD195SSX Owner's Manual

[] Supplied Accessories
owner's manual quick start guide
(1EMN24419) (1EMN24605)
remote control
(NF033UD)
batteries Phillips pan screw for
(AA x 2) attaching the stand x 3
(FPH34120)
. If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
[]Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
: Analog TV operation : Playback of DVD-video
: Digital TV operation : Playback of audio CD
, If neither symbol appears under the function heading, , If neither symbol appears under the function heading,
operation is applicable to both. operation is app icab e to both.
[] Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
!
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
_ Hang the hook under the bottom
of the main unit to the stand's hole
(shown arrow _i_),then slide down the
stand in the direction of the screen
(shown arrow _2)).Make sure not to
put the AC power cord between the
stand and the unit.
@
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by "(3_'_
Pull up the stand in the direction of the rear of the
unit. Becareful not to drop the stand when you
remove it.
Note:
_ Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand with a screwdriver tightly.
• When attaching the stand, ensure that aft screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
[]Tilt
Stand
You can adjust the stand to change the angle of the unit (-2.5 ° to 10%
110 °
EN