Changing The Emulation - Epson ActionLaser 1600 User Manual

Changing the Emulation

Before you can use the EpsonScript option, you need to change
the emulation by using the SelecType menus.
If you're using the LocalTalk interface, the emulation may
automatically be set for PostScript compatibility. However, it is
a good idea to check this setting before you begin printing.
To manually change your printer's emulation:
1. Press the Menu button.
displays the PRINTING MENU, which is the first menu of
the series.
2. Press the Menu button until EMULATION MENU appears
in the display.
3. Press the Item button until the interface you want to use is
displayed.
You can choose the parallel, serial, LocalTalk (L/T), or any
auxiliary interface.
Press the up arrow to select one of the following modes: PS,
4.
PS&LJ4, PS&FX, PS&ESCP2, PS&GL2.
5. Press the Enter button to add the value to printer memory.
6. Press the On Line button to put the printer back on line.
If you see the message RESET TO SAVE, press Reset while
you hold down the Alt button.
PostScript emulation is now assigned to the interface or
interfaces you selected in step 3. It stays selected until you
change the emulation for the interface.
3-2
Using EpsonScript in a Macintosh Environment
This takes the printer off line and