Advertisement
Surfaces
Stainless
Steel
(some models)
How to Clean
Clean stainless
steel with a dishcloth
using hot, soapy water. Rinse with clean water & a cloth.
Do not use cleaners
with
high
concentrations
of chlorides
or chlorines.
Do not use harsh
scrubbing
cleaners.
Only use kitchen
cleaners
that are especially
made for cleaning
stainless
steel. Always
be sure to rinse the cleaners
from the surface
as bluish stains may occur during
heating that cannot be removed.
Cleaning
the Cooktop
The cooktop is designed to make cleaning easier. Because the four burners are sealed, cleanups are easy when spillovers
are cleaned up immediately. To dean, wipe with a dean, damp cloth and wipe dry.
Cleaning
the Contoured
Well Areas,
Burner
Caps,
Head & Drip Pans (some models)
The contoured well areas, burner caps, burner heads and burner
drip pans (some models) should be routinely cleaned. Keeping
the burner ports clean will prevent improper ignitionand an
uneven flame. Refer to the following section for instructions.
Surface
Burner
Grate
NOTE: THE COOKTOP IS NOT REMOVABLE.
Do not attempt
to remove or lift the cooktop.
To Clean the Recessed and Contoured
Areas of the
Cooktop
- If a spill occurs on or in the recessed or contoured
areas, blot up spill with an absorbent cloth. Rinse with a clean,
damp cloth and wipe dry.
T°surfaceSUrfaceRem°VeburnerBUrner
Headsandgrate,Replace(2nd)
" Rem°Vesurface
burnercap,
the SurfaCein
thefollowingBUrner(3rd)CapSorder:surfaceand(lst
)
(_
S_u_!ie
burner head and (4th) surface burner drip pan (some models).
_
theSUrfaCeDOompletelyReVerse
the procedu
renOtsu_acebUrnerremoVecooledburners
w_houthead
andany
andPartsabOVesu_aCearefromtO
replace the su_ace burner
caP,safetheburner
dr_PthesurfacetoCOOktoPhandle.burnerPanSuntiiDo(_f
equipped).nOtcaptheYoperateandhave
_
__
surface
burner head properly in place.
Removable
To Clean the Surface Burner Cap, Surface
Burner Head &
Surface Burner Drip Pan (if equipped) - Use a soap-filled
scouring pad or a mild abrasive cleanser to clean the surface
burner caps, surface burner heads and surface burner drip pans
(if equipped). The ports (or slots) around the burner head must
be routinely cleaned. If residue still remains in these ports, use
a small-gauge wire or needle to clean the slots or holes. For
proper flow of gas and ignition of the burner--
DO NOT ALLOW
SPILLS, FOOD, CLEANING AGENTS ORANY OTHER
MATERIAL TO ENTER THE GAS ORIFICE HOLDER
OPENING. ALWAYS keep the surface burner cap and surface
burner head in place whenever a surface burner is in use.
Burner
Drip Pan
(on some models)
Use caution when replacing the burner
cap so the electrode is not damaged. This may cause a
delayed ignition or prevent the burner from igniting.
Any additions, changes or conversions
required in order for this appliance to satisfactorily meet
the application needs must be made by an authorized
Distributor or Qualified Agency.
9
Advertisement
