D-Roll Tray 1 Feed Removal - Lexmark T420 Service Manual

4048–00x
D–Roll Tray 1 Feed Removal
1. Remove the left cover and inner cover for the MPF gearing. See
"Left Side Cover Removal" on page 4-14
information.
2. Remove the duplex tray. See
Removal" on page 4-19
3. Disconnect extension spring [B] from the D–roll.
4. Release the latch on the paper feed solenoid. It is located
behind the lower right corner of the main drive assembly.
5. Rotate the main drive motor counterclockwise until the D–roll
clears the adjacent rib.
6. Using a slotted screwdriver as a wedge between the D–roll and
bearing wall, force the D–roll to unsnap from the shaft.
7. Slide the D–roll off the tray 1 feed shaft [A].
"Duplex Tray Assembly
for more information.
Repair Information
for more
4-35