Continuous Recording On Both Decks; Dubbing From Deck 1 Onto Deck 2 - Tascam 302mkII Owner's Manual

Using a Single Unit

Continuous Recording on Both Decks

When the tape on deck 1 records up to the end of the
reverse side, the tape on deck 2 will start recording,
stopping at its end of the reverse side.
The signal connected to DECK 1 is automatically
routed to DECK 2.
The procedure is essentially the same for Recording
on Either Deck, or Both at the Same Time, except:
" The switch must be set to
REV MODE

Dubbing from Deck 1 onto Deck 2

If you want to use an amp/speaker system to monitor
the source tape as it plays, connect your monitor
system to the output of deck 1.
1. Insert the source tape into deck 1 and a target tape
into deck 2.
2. Locate the source tape to the beginning of the
program material you intend to dub, and the target
tape to the point you want to start recording from.
switch to Ä to limit dubbing
3. Set the
REV MODE
to one side only or ä for dubbing to continue
onto the reverse side automatically.
4. Press the
DUB STDBY NORM
to dub selected portions or materials.
Use the mode when dubbing the entire
Hl SPEED
tape without interruption.
Upon selecting either DUB STDBY mode, deck 1
goes into Play Ready mode, and deck 2 goes into
Record Ready mode.
At this moment, ,
PLAY
operate on deck 1 if in NORM mode. In HI SPEED
mode, only can operate to change the record
PLAY
direction (STOP can also operate but only serves to
disengage the dubbing mode).
5. If you have connected a monitor speaker system to
the output of deck 1, and have selected the HI
10
TASCAM 302MKII
.
CONT
button if you intend
, and can
STOP F FWD REW
"
The INPUT/OUTPUT
.
SEPARATE
DUAL REC cannot be used in this application; put
both decks into Record Ready mode separately by
holding and pressing
RECORD
individual decks. (The
INPUT
and the switch also must be set on the
DOLBY NR
individual decks.)
SPEED mode, set the
.
SEPARATE
6. Press the
SYNC REVERSE
whichever tape first reaches the end of the forward
side to go into Play Pause or Record Pause mode
(depending on whether the tape is the source or
target), thus waiting for the other tape to reach its
end of the forward side, so that both tapes are
simultaneously switched to start their respective
functions on their reverse sides.
SYNC REVERSE can function only when :
l . REV MODE is set to ä ;
2. DUB STDBY is pressed before SYNC
REVERSE ; and
3. Both tapes start from their forward sides.
7. To start dubbing, press the Á button on deck 2.
8. If you are in NORM mode :
When dubbing of a selection is complete, locate the
tape to the beginning of the next selection to dub.
When you press
PAUSE
deck 1, deck 2 invariably goes into Record Pause
mode.
switch must be set to
E on the
PAUS
and controls
REC BAL
switch to
INPUT/OUTPUT
button if you want
, , or on
STOP F FWD REW