Targus universal security DEFCON VPCL User Manual

Introduction
Thank you for purchasing the Targus Universal Security DEFCON VPCL
Combination Cable Lock to help protect your valuable computer from theft.
The DEFCON is a 6-foot 5-inch vinyl coated, stainless steel cable with a
resettable 4-digit combination lock. It attaches to your computer, monitor or
projector via the VGA port by using the included pass-through video cable.
This allows you to continue using the video port while protecting your
computer.
Connecting the Pass-through Cable
1. Turn off your computer (if it is on).
2. Remove the current video cable, if there is one, from your computer.
3. Connect one end of the supplied pass-through cable to the video port on your
computer and the other end to your video device.
4. Turn on your computer.
Securing the DEFCON VPCL to an Object
Select an object in the room to which you will secure your computer with the
DEFCON VPCL. Choose a large, heavy piece of furniture such as a table or desk,
or immovable fixture such as a closet hanging bar.
1. Wrap the looped end of the cable around part of the selected object. Make sure
you use a part of the object that will prevent an intruder from slipping the cable
off (for example, a table or desk leg with a cross bar, or a drawer handle).
2. Feed the lock through the lopped end of the cable as shown.
Setting the Combination
1. Enter the current combination so that the numbers align horizontally with the embossed lines between
the dials. If you are setting the combination for the first time, enter the preset combination 0000.
2. Using a small flat-head screwdriver or similar object, push in and rotate the reset screw 90 degrees
counterclockwise so that the screw's groove is vertical.
3. Using the dials, enter the new combination.
4. Rotate the reset screw 90 degrees clockwise, back to its original horizaontal position to save the
new combination.
5. Record the combination in either the space provided at the end of this guide or another secure,
easy-to-find place.
NOTE: For best results, test the combination BEFORE attaching the lock to your computer via the pass-through
cable. Never attempt to remove the DEFCON VPCL without entering the combination. To do so may physically
damage the lock and your computer. Targus assumes no responsibility for lost misplaced, forgotten, lost, or
stolen combination.
Locking the Combination Lock
1. Enter the correct combination
2. Slide the lock onto the pass-through cable's elongated security screw as shown.
3. Turn the dials to conceal your combination. The DEFCON VPCL is now locked.
Unlocking and Removing the Combination Lock
1. Enter the correct combination.
2. Slide the combination lock off the security screws.
DEFCON PC Lock and Security Base Plate
Included with your DEFCON VPCL is the PC Lock and Security Base Plate for the security of desktop computers.
Using the DEFCON PC Lock
The PC Lock consists of a lock base, an attachment screw, and a security plate. When attached to a desktop computer, the lock
provides a convenient anchorage point for your DEFCON PC Lock or a notebook computer lock. The PC Lock does not require tools
for installation. However, you may want to use a screwdriver to securely fasten the lock to your computer. You can use either a Philips
or flat head screwdriver. Avoid overtightening the screw as doing so may cause damage to the screw's threading, making it difficult
to remove.
DEFCON is a trademark of Targus Group International. Features and specifications are subject to change without notice.
All trademarks and registered trademarks are the property of their respective owners. © 2006, Targus Group International, Inc. and Targus, Inc.
universal security
®
DEFCON VPCL
combination cable lock
Universal Security DEFCON VPCL
Combination Cable Lock
User Guide
Unlocking the combination lock
Locking the combination lock
Attaching the DEFCON VPCL to the
security screw
PA492U / 410-0222-001B