Epson PICTUREMATE PM 225 Basics Manual page 50

● Avoid places subject to dust, shock, or vibration.
● Leave enough room around the printer to allow for
sufficient ventilation.
● Place the AC adapter near a wall outlet where the plug can
be easily unplugged.
● Do not place or store the printer, the AC adapter, or the
optional battery outdoors.
● Do not block or cover the vents and openings in the
printer.
● Power supply cords should be placed to avoid abrasions,
cuts, fraying, crimping, and kinking. Do not place objects on
top of power-supply cords and do not allow the AC adapter
or power-supply cords to be stepped on or run over. Be
particularly careful to keep all power-supply cords straight
at the ends and the points where they enter and leave the
AC adapter.
● Use only the power-supply cord that comes with this
product. Use of another cord may result in fire or electrical
shock, or injury.
● The AC adapter model A431H is designed for use with the
printer with which it was included. Do not attempt to use it
with other electronic devices unless specified.
● Use only the type of power source indicated on the AC
adapter's label, and always supply power directly from a
standard domestic electrical outlet with the AC power cord
that meets the relevant local safety standards.
● Avoid using outlets on the same circuit as photocopiers or
air control systems that regularly switch on and off.
48
● Avoid using electrical outlets controlled by wall switches or
automatic timers.
● Keep the entire computer system away from potential
sources of electromagnetic interference, such as
loudspeakers or the base units of cordless telephones.
● Do not use a damaged or frayed power cord, or the AC
adapter or optional battery if damaged.
● If you use an extension cord with the printer, make sure
that the total ampere rating of the devices plugged into the
extension cord does not exceed the cord's ampere rating.
Also, make sure that the total ampere rating of all devices
plugged into the wall outlet does not exceed the wall
outlet's ampere rating.
● Never disassemble, modify, or attempt to repair the AC
adapter, power cord, printer, and options by yourself
except as specifically explained in the printer's guides.
Doing so may result in injury, electric shock, or fire.
● Unplug the printer and the AC adapter, remove the
optional battery from the printer, and refer servicing to
qualified service personnel under the following conditions:
The power cord or plug is damaged; liquid has entered the
printer; the printer, the AC adapter, or the optional battery has
been dropped or the casing damaged; the printer, the AC
adapter, or the optional battery does not operate normally or
exhibits a distinct change in performance. (Do not adjust
controls that are not covered by the operating instructions.)
● Do not use with wet hands.