Table of Contents
Advertisement
Batteries
Four "AAA" Alkaline batteries (not included) are required.
Battery Use and Safety
• Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries or different types of batteries.
• If you do not plan to use the remote for an extended period,
remove the batteries. They can leak chemicals that can destroy
electronic parts.
• Dispose of old batteries promptly and properly.
Do not burn or bury them.
To Install Batteries
1. Open the battery compartment cover (located on the back of
the remote).
2. Note the + and - polarity symbols inside the
battery compartment.
3. Insert the batteries, making sure their polarity matches the
symbols in the compartment.
4. Replace the cover.
NOTE: The LCD screen will display BATTERY LOW to indicate that
the batteries need to be replaced. The remote retains all its user
settings except for the day & time while replacing the batteries.
Battery Conservation
If any key is pressed continuously for 30 seconds the remote will
stop transmission to conserve battery life.
Automatic Time-Out
During programming, the remote will exit programming mode if
30 seconds elapses after the last key press.
If a key is pressed longer than 60 seconds while scrolling through
the menu screen, the remote will time-out.
Setup
1. Make sure the remote is in A/V mode. (Press & release the large
Z-Wave key at the top of the remote to cycle between A/V and
Z-Wave modes.)
2. Press and hold the SET key to enter setup mode.
3. Use the ARROW keys to scroll through the menus and the OK
key to select devices or actions.
6
Advertisement
Table of Contents
