GE ASD06 Owner's Manual & Installation Instructions page 11

Read completely, then follow step-by-step.
1
Window Requirements
These instructions are for a standard double-
hung window. You will need to modify them for
other types of windows.
The air conditioner can be installed without
the accordion panels if needed to fit in a narrow
window. See the window opening dimensions
below.
AS_06
and
AS_08
models
2
Storm Window Requirements
A storm window frame will not allow the air
conditioner to tilt towards the outside and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the stool.
1/2 higher
than frame
Storm window
frame
3
Remove the Front Grille, if attached
To remove the grille:
Remove shipping tape if present.
A
On models with a slide out air filter, remove
it (see the Care and Cleaning section) and
the screw behind it (if present) that holds
the grille in place.
On models with a raise up inlet grille, lift it
(see the Care and Cleaning section) and
remove the screw behind it (if present) that
holds the grille in place.
Pull the bottom grille corners out to release
B
the lower tabs on each side.
NOTE: Do not pull the bottom edge toward you more
than 3 inches or you may damage the tabs of the grille.
14 3 ⁄ min.
4
25 1 ⁄ to 37
2
(With accordion panels)
20 1 ⁄ min.
2
(Without accordion panels)
Wood
Stool
All supporting parts must be secured to firm
wood, masonry or metal.
The electrical outlet must be within reach of the
power cord.
AS_10
models
27 ⁄
5
8
(With accordion panels)
23 5 ⁄
(Without accordion panels)
WOOD PIECES—
WIDTH: 2
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place a
piece of wood on the stool to make it 1/2 higher
than the top of the storm window frame.
Attach securely with nails or screws provided by
the installer.
Lift the grille
C
up and off the
top tabs.
16 1 ⁄ min.
8
to 41
min.
8
11