Epson EQUITY Y14499113001 User Manual page 53

Epson personal computer user manual
Table of Contents

Advertisement

For detailed instructions on how to connect the drives to the optional
floppy disk controller card, consult the documentation supplied with the
card itself. The drive cables for drives A and B are normally connected to
connector CN5 on the system board (shown in Figure A-2). If a different
cable was supplied to connect the drives to the optional controller card,
make a careful note of how the original drive cable was connected, and
remove it from the computer. Keep it in a safe place, in case you need to
remove the optional controller for any reason.
J2
To disable the built-in floppy disk controller, you must first remove the
cover of the main unit (see "Removing the Cover" in Chapter 3). Then
locate Jumper J1 on the main system board, near the option slots, as shown
in Figure A-2. You may need to remove an option card from slot number five
in order to access this jumper. The factory setting is position A. To disable
the internal floppy disk controller, move the jumper to position B. If you
have also installed an additional disk drive, remember to adjust the appropri-
ate DIP switches on the front panel to match the number of drives installed.
A-2
FRONT
Figure A-2. Jumper locutions
6M and 6N
7M and 7N

Advertisement

Table of Contents
loading

This manual is also suitable for:

Equity iEquity i+

Table of Contents