About Backing Up (Copying) Images - Canon EOS-1Ds Software Manual

About Backing up (Copying) Images

●
It is recommended that you should back up (copy) the captured images into the hard disk of
your computer, etc. before working with EOS DIGITAL SOLUTION DISK.
●
Use only the interface cable bundled with the camera to connect the camera to
your computer.
●
Push the plug firmly all the way into the socket. Loose connections can cause
faults or malfunctions.
●
Connect the camera to the computer directly using the interface cable. The camera
and computer may not operate correctly if you connect them via a hub or if you
connect to multiple IEEE1394 devices.
●
Do not connect more than one camera to the same computer. The connections
may not operate correctly.
●
While the camera and your computer are communicating, the camera's LCD
panel may blink and, if you are using the LCD monitor, the image on the monitor
may flicker. This is not malfunction.
●
If you do not perform any operation while the camera and computer are connected,
a confirmation message appears on the computer screen asking whether you wish
to continue communicating with the camera for some computer systems. If you do
not perform any operation even after this message appears, the communication
with the camera is terminated. (If you are using a household power source, no
message is displayed and the connection is not terminated.) To re-establish the
connection, press the shutter button down halfway or set the camera's main
switch to <OFF> and then back to <ON>.
●
Do not put your computer to sleep while it is connected to the camera.
If you do put your computer to sleep while it is connected to the camera, never
disconnect the interface cable while your computer is still in sleep mode. Always
wake your computer up before disconnecting the camera. On some types of
computer, disconnecting the interface cable while your computer is in sleep mode
could prevent the computer from waking up correctly. Refer to the computer
User's Manual for more information on Sleep mode.
●
When you connect your camera to a computer, you should use the DC Coupler Kit
so that you can continue to use your camera regardless of battery level. It is
recommended that you should set the camera's Auto power off function to [Off].
●
If your computer has a 4-pin IEEE1394 port, purchase a Canon 4-pin to 6-pin
interface cable (optional).
Connecting the Camera to Your Computer
2-3