Table of Contents
Advertisement
Compro IP55/60/70 Network Camera
Profile Management
The profile management feature allows installers and users to set up more than one camera of similar
configurations at great ease. After the current camera is properly configured, users can export current
configurations to a profile on PC and then import it into other cameras, thus making least changes possible
like changes on IP address or a few other settings that might need to be modified individually. In addition,
this feature can also be considered as a backup mechanism for future service need.
1. After the current camera is properly configured, go to [Maintenance] > [Profile Management], and
click on [Export] to download camera profile to a user-defined location.
2. To apply configurations to other cameras, press [Browse...] and select the right file you wish to upload,
and then click on [Import] to proceed.
3. Camera will start to reboot, which will take approximately 60 seconds to complete. User must not
interrupt browser action during the process as doing so may cause problems to the system.
Reset All Settings to Default
This will reset IP camera to its factory default settings, producing the same result as pressing the hardware
rest button at the back of camera. If you need to perform hardware reset, refer to the Troubleshooting
chapter.
Firmware Update
You can download the latest firmware from Compro's website (www.comprousa.com). After downloading
the firmware, please open the web interface for IP camera setting, and click Setup à Maintenance (top-right)
à Maintenance (left menu) and look for firmware update section. Press the Browse button and locate the
downloaded firmware file and press Upgrade button to update camera firmware.
7-2
Maintenance
Warning!
you may only cross-import profile among identical
camera models.
Figure 7-4. Firmware update
Advertisement
Table of Contents
