Table of Contents
Advertisement
Position the power supply cable connector so that the
notched corners on the connector line up with the notched
corners of the power supply socket on your drive.
notched corners
Make sure the holes fit over all the pins and then push the
connector onto the pins.
Caution
If
you do
not
could severely damage your drive when you push in the
connector.
If you do not need to reinstall a vertically mounted hard disk
drive, see "Replacing the Subassembly" on page B-47.
If you
connected the power supply cable to your
just
vertically mounted hard disk drive, perform step 8 again to
connect the power supply cable to the drive you just
installed in the horizontal drive bay. Then see "Replacing
the Drive on the Subassembly" on the next page for
instructions on reinstalling the vertically mounted hard disk
drive.
correctly align the holes with the pins, you
Installing and Removing Disk Drives
notched corners
B-41
Advertisement
Table of Contents
