Advantek Networks (USB 2.0) User Manual page 40

Management Systems are available from many third-party vendors, such as Hewlett-Packard's
OpenView.
When accessing (traversing) MIB objects in the print server using NMS software called
SNMP manager, you need to provide a community name in each SNMP request for
authentication purpose. The print server supports up to two community names. The default
community name is public (case-sensitive), with Read Only access right in default.
When an unusual condition or activity occurs, the SNMP agent alerts the SNMP manager
through SNMP traps. Following list summaries SNMP trap messages that the print server will
send out.
Activities/SNMP Trap Messages / Description
Link Up or Link Down / When the network interface on the print server fails, a link down trap
Cold Start or Warm Start / When the print server restarts, the cold start or warm start trap
Authentication Failure / When the print server received a SNMP request with a community
In the print server's SNMP implementation, the following MIB objects are available for updating.
MIB Object Names / Description
system.sysContact / Indicates the network administrator's name.
system.sysName / Indicates the print server's name for identification.
system.sysLocation / Indicates the location of the print server.
snmp.snmpEnableAuthenTraps / Enables or disables the function of sending SNMP
Users can set up print server's SNMP functions by using their browsers.
1.Click Setup, it then appears the sub-menu.
2.Click SNMP, it then as shown in the following picture.
message is generated; if the network interface comes back to
life, a link up trap message is sent.
message is generated.
name that does not match the community name the print server
is configured with (stored in the print server's memory), an
authentication failure trap message is generated.
Authentication Failure
administrator, if the community name within a SNMP request is
not correct.
trap message to the network