Epson S7 User Manual page 75

Replacing Consumables
Caution
Wait until the Lamp has cooled down sufficiently before removing the Lamp
cover. If the lamp is still hot, burns or other injuries may result. It takes
about one hour after the power has been turned off for the Lamp to be cool
enough.
Procedure
A
After you turn off the projector's power and the
confirmation buzzer beeps twice, disconnect the power cable.
B
Wait until the Lamp has cooled down, then remove the
Lamp cover.
Loosen the Lamp cover fixing screw with the screwdriver supplied
with the new lamp unit or a + head screwdriver. Then slide the
Lamp cover straight forward and lift it to remove.
C
Loosen the two Lamp fixing screws.
D
Take out the old Lamp by pulling the handle.
If the Lamp is cracked, replace it with a new lamp, or contact
your local dealer for further advice.
List
75
Epson Projector Contact
s