Operation; Using The Dryer - Bosch Household Appliances WTC82100US Operating, Care And Installation Instructions Manual

Operation
Using the dryer
1. Open the door.
2. Check lint filter.
The filter should be cleaned
after and before every drying
process. Cleaning the filter
reduces the drying time and
saves energy.
Start
O
)
3. Rotate program selector to the
desired program.
Select the program which
corresponds to the laundry in
the dryer from the program
selection table (see page 23).
The Start/Stop indicator light starts
flashing.
ITllf lint filter indicator flashes -
Check lint filter!
_tart Low Wr nkle
heat irentng _ bIockiEnd
L Filter
%
4. If required, select Low heat
by pressing the button.
The Options are explained
on page 15,
5. If required, select Easy ironing
by pressing the button.
The Options are explained
on page 15.
6. Place laundry in the empty
,
,
%
drum, Put each piece of laundry
into the machine separately.
For best results the laundry
to be dried must be sorted
according to type of laundry
and desired degree of drying.
Observe drying symbols of the
laundry manufacturer.
Ensure that there is only
laundry in the drum. Check that
all items are completely in the
drum and that none are caught
between the door and the dryer
housing or door seal.
Close the door.
If the door has not been closed
properly, the dryer will not start,
Start
9. Press the Start/Stop button.
The Start/Stop indicator light
illuminates.
Low
heat ilon ng
O O
f,- ,,,
%
%
At program end the LED
Wrinkle block/End flashes.
When the drying process is
complete (program or selected
time program ended), the drum
rotates at specific intervals.
This prevent the laundry from
creasing (see Easy ironing,
page 15).
10. Open the door.
11. Take the laundry out of the
dryer.
12. Rotate the program selector to
Off. The dryer light goes out,
13. Clean the filter.
The filter should be cleaned
after each drying process.
Cleaning the filter reduces the
drying time and saves energy.
14. Close the door.
16