Replacing The Oven Door - GE JKP15 Installation Instructions Manual

Installation Instructions
Preparing for the bottom
C3
Trim Installation
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim as
a template mark
the center of
each slot (three
total) where
the mounting
holes will be
drilled.
c. Remove the trim.
d. Drill pilot holes into the center of each
template mark.
Installing the Bottom
C4
Trim
a. Place the bottom trim centered over the
pre-drilled mounting holes. Tape the edges
of the trim down to maintain the alignment.
Trim
Screw
Side
Trim
b. Using the three pan head trim screws
provided secure the bottom trim to the
bottom edge of the cabinet.
IMPORTANT: If this unit is ever removed
from the cabinet or the cavity is ever
pulled out for service, the trim must be
removed first or damage to the trim will
occur.
With Lower Trim With Lower Trim
In Position In Position
Mark (3) Mounting Mark (3) Mounting
Hole Locations Hole Locations
Remove Lower Trim
Before Pre Drilling
Mounting Holes
Side
Trim
Lower
Trim
Replacing the Oven
D
Door
The oven door is heavy. You may need
help lifting the door high enough to
slide it into the hinges slots. Do not lift
the door by the handle.

Replacing the Oven Door

Pick the Oven Door up by
D1
placing one hand on each
side. The door is heavy so
you may need help. Do not
lift the door by the handle.
Place the notch of the
D2
hinge arm into the
bottom edge of the
hinge slot.
D3 Open the oven door as
far as it will open.
Push the hinge locks
D4
up against the front
frame of the oven
cavity, to the locked
position.
D5
Close the oven door.
11
Hinge Arm
Bottom Edge
Of Slot
Hinge Notch
Hinge in
Locked Position
Notch of
Hinge Securely
Fitted into Bottom
of Hinge Slot