Samsung PN51D490A1DXZA E-Manual page 9

When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings. To turn on
the TV, press the POWER3 button.
✎
Plug & Play is available only when the Source is set to TV.
✎
To return to the previous step in the Plug & Play sequence, press the red button, and then press ENTER(.
✎
Before turning on the TV, make sure you have connected the TV to an antenna or cable connection (p. 8).
1 Selecting the OSD
Language
2
Selecting the usage
mode
3
Setting the Clock
Mode
4
Selecting search
options for auto tuning
5
Selecting and
memorizing channels
6
Enjoy your TV.
If You Want to Rerun Plug & Play...
"
MENU System Plug & Play
✎
NOTE
y To change the TV's setting from Store Demo to Home Use when not in Plug & Play, press the volume button on the TV.
When you see the volume bar on the screen, press and hold the
Plug & Play (Initial Setup)
Press the or button to select a language. Press ENTER( twice
when done.
Press the or button to select Home Use, and then press the
ENTER( button twice.
Select Home Use mode. Store Demo mode is for retail environments.
Press the or button to select Auto or Manual, and then press ENTER( twice.
✎
If you selected Auto, you'll go to the Time Zone and DST screen. Select Time Zone
or DST, and then press ENTER(. On the Time Zone screen, use the
button to select your zone, and then press ENTER(. On the DST screen, press,
ENTER(, then select whether to turn DST (Daylight Savings Time) on or off. When
done, press ENTER(.
✎
If you selected Manual, you'll go to the Date and Time screen. Select Date or Time,
and then press ENTER(. Then, use the number buttons or the
set the date or time. Use the
done setting the Date and Time, select Next, and then press ENTER(.
Press the or button to select Air or Cable, and then press ENTER(. A check
appears on your selection. Select Next, and then press the ENTER( button. You can
check both if you have both connected.
✎
If you selected Cable, you'll go to the Cable System screen. Use the
to select Digital or Analog, and then press. ENTER(. Use the
to select the correct cable signal format - STD, HRC, or IRC - and then press
ENTER(. Most cable systems use STD. Select the correct cable signal format for
both the Digital and Analog systems.
When done, select Next, and the press ENTER(.
The channel search will start automatically. This can take up to 30 minutes.
For more information, refer to Channel
✎
Press the ENTER( button at any time to interrupt the memorization process.
Press the ENTER( button.
ENTER(
(QJOLVK 
or button to move between entry fields. When
Auto Program in the e-Manual.
MENU button on the TV for 5 sec.
POWER
P
or
or button to
or button
or button