Miu Menu - Hitachi CP-X467 Operating Manual

MIU menu

The MIU (Multi Information processing Unit) is a function to
support the Network features and PC-LESS Presentation.
Consult with your network administrator before connecting to
an existing access point on your network. Incorrect network
settings on this projector may cause trouble on the network.
Select "MIU" from the main menu to access the following
functions.
Select an item using the ▲/▼ cursor buttons on the projector or remote control, and
press the ► cursor button on the projector or remote control, or ENTER button on the
remote control to execute the item. Then perform it according to the following table.
See the User's Manual - Network Guide for details of MIU operation.
NOTE
• The factory default setting for DHCP is OFF. If your network has
DHCP enabled, and needs to set IP ADDRESS, SUBNET MASK and DEFAULT
GATEWAY automatically, please set DHCP to ON (60).
• If you are not utilizing SNTP (Date/Time Settings of the User's Manual - Network
Guide), then you must set the DATE AND TIME (61) during the initial installation.
• The network communication control is disabled while the projector is in
standby mode if the STANDBY MODE item of SETUP menu is set to SAVING.
Please connect the network communication to the projector after setting the
STANDBY MODE to NORMAL (38).
Item
Selecting this item sets the projector onto the "Live Mode".
On the "Live Mode", the projector displays the images from the PC via
LIVE MODE
Network, supported by "Live Viewer 3" software (
User's Manual - Network Guide).
Selecting this item displays the LIVE MODE
SETTING menu.
Use the ▲/▼ buttons to select an item, and
the ► or ENTER button to perform the item.
LIVE MODE
SETTING
PRESENTER
(continued on next page)
The Presenter Mode that is set in the "Live Viewer 3" software
installed into your PC can be turned to off.
A message, QUIT PRESENTER MODE, will
be displayed in about 3 seconds when the
function is performed. The function is available only when the
QUIT Presenter Mode is set to on in the the "Live Viewer 3" software.
The current setting of the Presenter Mode is shown in the menu.
MODE
• The Presenter mode is a function that allows the projector
to display an image sent by 1 PC only, even though the MIU
feature on this projector support Multi PC mode.
• If the projector is required to display an image sent by
other PC, execute the QUIT PRESENTER MODE function.
• See the User's Manual – Network Guide for details.
Description
MIU menu
Live Mode of the

57