Sears Craftsman 917.251570 Owner's Manual page 26

TO REPLACE HEADLIGHT BULB
o Raise hood,.
* Pull bulb holder out of the hole in the backside of the
grilL,
o Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill°
, Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting°
o Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual,,
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse_ The
fuse holder is located behind the dash.
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 33)
• While holding spring bushing with wrench, loosen jam
nut,
o Turn adjustment bolt clockwise to extend spring and
reduce lift effort for heavier attachments.
. Turn adjustment bolt counterclockwise for lighter at-
tachments,,
= Retighten jam nut against spring bushing°
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER_ ADJUST LtFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING,
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 34)
, Raise hoo&
° Unsnap headlight wire connector_
. Stand in front of tractor. G rasp hood at sides, tilt toward
engine and lift off of tractor.
o To repiace, reverse above procedures.
HOOD
FIG. 34
ADJUSTMENT SPRING BUSHING
BOLT
e ATf'ACHMENT
JAM NUT LIFT SPRING
o o
FIG. 33
26