Table of Contents
Advertisement
STEP
10:
(SEE FIGURE 11)
•
Place the star washer (L) between the height
adjustment handle and the height adjustment strap.
Insert the 5/16" x 1" carriage bolt (F) through the
height adjustment handle, the star washer and the
height adjustment strap. Assemble a 5/16" flat washer
(K) and the plastic knob (X) onto the end of the bolt.
ASSEMBLY
OF HOPPER BAG
STEP 11: (SEE FIGURE
12 AND 13)
Turn a rear hopper tube so that the brace holes in the
middle of the tube face down. Slide the tube through
the two loops sewn to the top rear seam inside the
hopper bag.
5/16" × 1"
CARRIAGE BOLT (F)
STAR WASHER (L)
(between atrap and handle)
5/16" FLAT
WASHER (K)
PLASTIC KNOB (X)
/
FIGURE 11
INNER BAG LOOPS
REAR HOPPER TUBE
(brace holes on bottom)
FIGURE 12
®
®
Insert the two upper hopper side tubes through the
stitched flaps on each side of the hopper bag.
Assemble the ends of the rear hopper tube onto the
ends of the upper hopper side tubes. Fasten together
using plastic plugs (Z).
_,jPLASTIC
PLUG (Z)
UPPER HOPPER
SIDETUBE
FIGURE
13
Advertisement
Table of Contents
