Craftsman 351.217030 Operator's Manual page 3

• Userecommended accessories ( refer to page19).
Useofimproper accessories m aycauseriskof
injuryto persons.
• Handle workpiece correctly. Protect h ands frompos-
sibleinjury.
• Turnmachine off if itjams.Blade jamswhenit digs
toodeeply intoworkpiece. (Motor forcekeeps it
stuckinthe work.)
CAUTION:Thinksafety! S afety is a combination o f
operator c ommon senseandalertness atalltimes
whentoolis beingused.
Refer t o Figure 1.
Check forshipping damage. If damage hasoccurred, a
claimmustbefiledwithcarrier. C heck forcomplete-
ness. I mmediately reportmissing partsto dealer.
Thejointeris shipped complete i n onecratealongwith
a cartonforthestand. A dditional partswhichneedto
befastened tojointerandjointerstandshouldbelocat-
edandaccounted f orbefore assembling.
A. Jointer
B. Stand
C. Fence
D. FenceBracket Assembly
E. FenceLocking Handle
E PushBlock(2)
G. PushBlockHolder
H. BladeGauge
I. BladeGuard Assembly
J. BeltGuard
K. Locking Studs(3)
L. Handwheel Assembly ( 2)
M.DustPort
N. V-Belt ( 2)
AngleGauge (NotShown)
Hardware B ag(PartNo.23200.00) includes Fence Grip
Handle, M 10FlatWasher ( 3),M10LockWasher ( 3),
M5x 10Socket H eadBolt(4),M5FlatWasher ( 4),5 x
5 x 25mmKey(2),3,4 and5mmhexwrenches,
8/10mm, 12/14mm and17/19mm openendwrenches.
IMPORTANT: Table is coated witha protectant. To
ensure proper f it andoperation, remove coating.
Coating is easilyremoved w ithmildsolvents, suchas
mineral s pirits, a nda softcloth. A voidgetting solution
onpaintor anyofthe rubber o r plasticparts. S olvents
maydeteriorate t hesefinishes. Usesoapandwateron
paint,plastic or rubber components. Aftercleaning,
coverallexposed surfaces w itha lightcoating of oil.
Paste waxis recommended fortabletops.
WARNING:Never u sehighlyvolatile solvents. Non-
flammable s olvents a rerecommended toavoidpossible
firehazard.
G
:igure 1 - Unpacking
[
M
E /
[
CAUTION: Do not attempt assembly if parts are miss-
ing. Use this manual to order replacement parts.
JOINTER INSTALLATION
Refer to Figure 2.
Before jointer or stand are assembled, a suitable loca-
tion should be chosen. The jointer and jointer stand
weigh approximately 400 Ibs when completely assem-
bled. They should be assembled on location.
• Jointer needs to be set on a flat, level surface.
• Make sure there is ample room on either side of
jointer to accommodate desired workpiece size.
• Good lighting and correct power supply are also
required for a proper work area.
• Place stand in its designated spot. Door panel for
access to motor is on back side.
.._e_Blade Guard Assembly
T-Handle Bolt
\
Key
Handwheel
Screw
=igure 2 - Jointer Assembly
Flat Washer
Lock Washer
Locking Stud