Handle; Spark Plug; Storage - Craftsman 917.376301 Owner's Manual

STORAGE
Immediately prepare your lawn mower for storage at the
end of the season or if the unit win not be used for 30 days
or more.
LAWN MOWER
When lawn mower is to be stored for a period of time, clean
it thoroughly, remove al! dirt, grease, leaves, etc. Store in
a clean, dry area.
° Clean entire lawn mower (See "CLEANING" in the
Customer Responsibilities section of this manual).
• Lubricate as shown in the Customer Responsibilities
section of this manuat.
• Be sure that all nuts, bolts, screws, and pins are
securely fastened, lnspect moving parts for damage,
breakage and wear. Replace if necessary.
• Touch up all rusted or chipped paint surfaces; sand
lightly before painting.
HANDLE (See Fig. 18)
You can fold your tawn mower handle for storage.
• Squeeze the bottom ends of the lower handle toward
each other until the lower handte clears the handle
bracket, then move handle forward.
• Loosen upper handle mounting botts enough to aItow
upper handle to be folded back.
IMPORTANT: WHEN FOLDING THE HANDLE FOR
STORAGE OR TRANSPORTATION, BE SURE TO FOLD
THE HANDLE AS SHOWN OR YOU MAY DAMAGE THE
CONTROL CABLES:
• When setting up your handle from the storage position,
the lower handle will automatically lock into the mowing
position.
LOWER HANDLE
HANDLE
BRACKET
SQUEEZE TO
FOLD
HAIRPIN
COTTER
OPERATOR PRESENCE
CONTROL BAR
UPPER HANDLE
FOLD FORWARD
FOR STORAGE
FOLD BACKWARD
MOWING
POSITION
LOWER HANDLE
ENGINE
FUEL SYSTEM
iMPORTANT: IT _S IMPORTANT TO PREVENT GUM
DEPOSITS FROM FORMING tN ESSENTIAL FUEL
SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER,
FUEL HOSE,
OR TANK DURING STORAGE.
ALSO,
EXPERIENCE iNDICATES THAT ALCOHOL BLENDED
FUELS (CALLED
GASOHOL OR USING ETHANOL OR
METHANOL) CAN ATTRACT MOESTURE WHICH LEADS
TO SEPARATION AND FORMATION OF ACEDS DURENG
STORAGE, ACrD_C
GAS CAN DAMAGE THE FUEL
SYSTEM OF AN ENGINE WHILE IN STORAGE.
• Drain the fuel tank.
• Start the engine and let it run until the fuel tines and
carburetor are empty.
• Never use engine or carburetor c_eaner products in the
fuel tank or permanent damage may occur.
, Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum deposits during stor-
age. Add stabilizer to gasoline in fuel tank or storage
container. Always follow the mix ratio found on stabilizer
. container. Run engine at least 10 minutes after adding
stabilizer to allow the stabilizer to reach the carburetor. Do
not drain the gas tank and carburetor if using fuet stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace with clean engine
oil. (See "ENGINE" in the Customer Responsibilities
section of this manual).
CYLINDER
• Remove spark plug.
• Pour one ounce (29 mti of oil through spark plug hole
into cylinder.
• Pull starter handle slowly a few times to distribute oil.
• Replace with new spark plug.
OTHER
• Do not store gasoline from one season to another.
• Replace your gasoline can if your can starts to rust.
Rust and/or dirt in your gasoline will cause problems.
• If possible, store your unit indoors and cover it to give
protection from dust and dirt.
• Cover your unit with a suitable protective cover that
does not retain moisture. Do not use plastic. Plastic
cannot breathe which allows condensation to form and
win cause your unit to rust.
IMPORTANT: NEVER COVER MOWER WHfLE ENGINE
AND EXHAUST AREAS ARE STILL WARM.
CAUTION: Never store the lawn mower
with gasoline in the tank inside a build-
ing where fumes may reach an open
flame or spark. Allow the engine to cool
before storing in any enclosure.
FIG. 18
17