Mounting The Print Cartridge - Fujitsu fi-553PR Operator's Manual

7. Connect the power cable to the scanner.

2.2. Mounting the Print Cartridge

Mount the print cartridge as follows:
ATTENTION When installing or replacing the Print Cartridge, be
careful not to insert it out of place.
1. Confirm that the scanner is turned off.
2. Grab both ends of the Print Section Cover, pull
and turn it towards you to open the cover.
3. Remove the tape which fixes the Print Cartridge
Holder.
4. Pinch the Arm with your fingers as shown below
and release the Arm.
5. Take out the Print Cartridge from the bag.
6. Remove protection tape on the Print Cartridge.
6 |
Print Cartridge Holder
ATTENTION Do not touch the metal part of the Print
Cartridge nor put the tape back again.
7. Put the Print Cartridge into the holder as below.
ATTENTION Be careful not to let the Print Cartridge catch
the print circuit film.
8. Lower the Arm gently until it locks in and fix the
Print Cartridge in place.
9. Move the Print Cartridge Holder to an appropriate
printing position.
The holder should be positioned where the printing
area of document (Section 6) will pass under it.
10. Close the Print Section Cover.