Before You Call - Frigidaire FPHG2399MF Use & Care Manual

Complete owner's guide (english)
Hide thumbs Also See for FPHG2399MF:
Table of Contents

Advertisement

1-800-944-9044 (United States)
1-800-265-8352 (Canada)
CONCERN
AUTOMATIC ICE MAKER
Ice maker is not mak-
ing any ice.
Ice maker is not mak-
ing enough ice.
Ice maker will not stop
making ice.
Ice cubes are freezing
together.
OPENING/CLOSING OF DOORS/DRAWERS
Door(s) will not close.
Drawers are difficult to
move.
POTENTIAL CAUSE
Ice maker power switch is Off.
Ice maker has small cube
caught in mechanism.
Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
Ice maker is producing less ice
than you expect.
Check to see if water dispenser
is dispensing slower than normal.
Ice maker wire signal arm is
being held down by some item
in the freezer.
Ice cubes are not being used
frequently enough.
Ice cubes are hollow (partially
frozen cubes with water inside).
Freezer control is set too warm.
Door was closed too hard, caus-
ing other door to open slightly.
Refrigerator is not level. It
rocks on the floor when moved
slightly.
Refrigerator is touching a wall
or cabinet.
Food is touching shelf on top of
drawer.
Track that drawers slide on is
dirty.

BEFORE YOU CALL

COMMON SOLUTION
Turn power switch to On ("I") position.
Remove small cube from ice maker. The ice and water
filter cartridge may be clogged. Replace filter cartridge.
Turn off household water line valve. Remove valve. En-
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
The ice maker produces approximately four (4) pounds of
ice every 24 hours depending on usage conditions.
If it is, replace the ice and water filter cartridge.
Move item and release wire signal arm. Remove any ice
cubes that are frozen together over the wire signal arm.
Remove ice container and discard ice from container. Ice
maker will produce fresh supply.
The ice and water filter cartridge may be clogged. Replace
filter cartridge.
Set freezer control to colder setting. Allow 24 hours for
temperature to stabilize.
Close both doors gently.
Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
Remove top layer of items in drawer.
Ensure drawer is properly installed on track.
Clean drawer, rollers, and track. See Care & Cleaning.
Visit our web site at
www.frigidaire.com.
27

Advertisement

Table of Contents
loading

Table of Contents